Refer to the exhibit. The network has converged and Switch_6 has been elected root bridge of the STP tree. However, network traffic analysis indicates that Switch_1 would be a better root bridge. How can the network administrator make this change, assuming that the spanning-tree priorities are at the default settings?

Last Updated on April 26, 2021 by Admin

Refer to the exhibit. The network has converged and Switch_6 has been elected root bridge of the STP tree. However, network traffic analysis indicates that Switch_1 would be a better root bridge. How can the network administrator make this change, assuming that the spanning-tree priorities are at the default settings?

CCNPv8 ENCOR (Version 8.0) - L2 Redundancy Exam Answers 02

CCNPv8 ENCOR (Version 8.0) – L2 Redundancy Exam Answers 02

  • Set the bridge priority of Switch_1 to 32,768.
  • Set the bridge priority of Switch_6 to 65,565.
  • Set the bridge priority of Switch_1 to 4,096.
  • Set the bridge priority of Switch_6 to 255.
    Answers Explanation & Hints:

    The switch priority is a value between 0-61,440 in increments of 4,096. Switch priority is initially set to 32,768 (the default). Therefore, Switch_1 can become the root bridge if the priority is set to a value between 0-28,672.

0 0 votes
Article Rating
Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments