Refer to the exhibit. Router R1 has an OSPF neighbor relationship with the ISP router over the 192.168.0.32 network. The 192.168.0.36 network link should serve as a backup when the OSPF link goes down. The floating static route command ip route 0.0.0.0 0.0.0.0 S0/0/1 100 was issued on R1 and now traffic is using the backup link even when the OSPF link is up and functioning. Which change should be made to the static route command so that traffic will only use the OSPF link when it is up?​

Last Updated on April 27, 2021 by Admin

Refer to the exhibit. Router R1 has an OSPF neighbor relationship with the ISP router over the 192.168.0.32 network. The 192.168.0.36 network link should serve as a backup when the OSPF link goes down. The floating static route command ip route 0.0.0.0 0.0.0.0 S0/0/1 100 was issued on R1 and now traffic is using the backup link even when the OSPF link is up and functioning. Which change should be made to the static route command so that traffic will only use the OSPF link when it is up?​

CCNPv8 ENCOR (Version 8.0) – Chapters 6 – 7 Routing Essentials and EIGRP Exam Answers 04

CCNPv8 ENCOR (Version 8.0) – Chapters 6 – 7 Routing Essentials and EIGRP Exam Answers 04

  • Add the next hop neighbor address of 192.168.0.36.
  • Change the administrative distance to 1.
  • Change the destination network to 192.168.0.34.
  • Change the administrative distance to 120.
    Answers Explanation & Hints:

    The problem with the current floating static route is that the administrative distance is set too low. The administrative distance will need to be higher than that of OSPF, which is 110, so that the router will only use the OSPF link when it is up.

0 0 votes
Article Rating
Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments