Refer to the exhibit. An administrator is trying to configure the switch but receives the error message that is displayed in the exhibit. What is the problem?

Last Updated on March 24, 2021 by Admin

Refer to the exhibit. An administrator is trying to configure the switch but receives the error message that is displayed in the exhibit. What is the problem?

Modules 17 - 20 Introduction to Cisco Networking Pre-Test Exam Answers 01

Modules 17 – 20 Introduction to Cisco Networking Pre-Test Exam Answers 01

  • The entire command, configure terminal , must be used.
  • The administrator is already in global configuration mode.
  • The administrator must first enter privileged EXEC mode before issuing the command.
  • The administrator must connect via the console port to access global configuration mode.
    Answers Explanation & Hints:

    In order to enter global configuration mode, the command configure terminal , or a shortened version such as config t , must be entered from privileged EXEC mode. In this scenario the administrator is in user EXEC mode, as indicated by the > symbol after the hostname. The administrator would need to use the enable command to move into privileged EXEC mode before entering the configure terminal command.

0 0 votes
Article Rating
Subscribe
Notify of
guest
0 Comments
Inline Feedbacks
View all comments